Hi - happy with what I received but not quite what I wanted - my fault I assumed that service manual would also include operational instructions which is what I needed - all I needed to know was how to turn the radio - thanks
this Manual very important when i buy this Manual i already fix the trouble of my Camera..... thanks keep up the good work.!
Text excerpt from page 1 (click to view)
MATSUI VP 9405
Matrix
Item See Model Book
6 6 6 Deck Exploded View ............................................................................ VXA 1105 Deck Alignment .................................................................................... VXA 1105 Deck Adjustments ................................................................................ VXA 1105
1
Head Amp Diagram
Electrical Adjustments
3. ADJUSTMENT PROCEDURE Read and perform these adjustments when repairing the circuits or replacing electrical parts or PCB assemblies. CAUTION When replacing IC�s or transistors, use only specified silicon grease (YG6260M). (To prevent the damage to IC�s and transistors.) 3-1: PG SHIFTER CONDITIONS MODE-PLAYBACK Input Signal-Alignment Tape (JG001C) INSTRUCTIONS 1. Playback the alignment tape. (JG001C) 2. Press both Tracking AUTO key on the Customer remote control and the PLAY button on the set simultaneously until the indicator ATR disappear�s. If the indicator ATR disappear�s, the adjustment is finished. (If the ATR indicator is still illuminated) 1. Connect CH-1 on the oscilloscope to TP4001 and CH-2 to Pin 19 of J4501. 2. Press the PG AUTO key. (JG155) 3. While the ATR indicator is flashing, press the PG MANUAL key. (JG155) 4. Adjust the Tracking +/- key until waveform of the oscilloscope measures 6.5 ± 0.5(H) at both leading and trailing edges. (Refer to Fig. 3-1-A, B) 5. Press the Tracking Auto key.